Charging Converter VCC 1212-70

Article-No. 3328

 

Reisemobil

Offroad

Blaulicht

VCC B

Battery-to-Battery (B2B)
Charging Technology

1212

Starter Battery   Supply Battery


Euro6 EN

Description

  • The efficient charging converter ensures high charging capacity, already within short distances.
  • Full charging when driving longer distancesIt increases/reduces the voltage to the level, which is required for precise charging of the board battery with the optimum charging characteristic line.
  • Cable losses and considerable voltage fluctuations of the generator, known from Euro 6 vehicles (intelligent alternators), are completely compensated.
  • The charging converters excel by their compact design, low weight (high-frequency switch mode technology) and powerfully dimensioned power components for safe operation.
  • The energy balance of the board battery is considerably improved, without intervention into the starter circuit.
  • The simultaneously supplied 12 V consumer loads are protected against overvoltage and voltage fluctuations.
  • The charging voltage is free from peaks and is controlled in such a way, that overcharging of the batteries is excluded.
  • Fully Automatic Operation: The unit is permanently connected to the batteries, and it is automatically activated by the running generator of the vehicle. Battery discharge in case of an engine stop is avoided.
  • Parallel and Floating Operation: In case of simultaneous consumption, the battery will either continue to be charged or maintained via trickle charging. Calculation and control of the adaptation of the charging times is effected automatically by the unit.
  • Unattended Charging: Multiple protection against overload, overheating, overvoltage, short circuit, incorrect behaviour and back discharge of the battery by electronically controlled gradual reduction down to complete separation of unit and battery.
  • Integrated On-board Mains Suppression Filter: Unproblematic parallel operation of charging sources (EBL, chargers, motor-driven and petrol-driven generators, solar systems) on one battery.
  • Charging Cable Compensation: Automatic compensation of voltage losses on the charging cables.
  • Connection for Battery Temperature Sensor (included in the standard delivery scope): Lead batteries (acid, gel, AGM): In case of low outside temperatures, full charging of the weak battery is improved by automatic adaptation of the charging voltage to the battery temperature, and in case of summery temperatures unnecessary battery gassing will be avoided. LiFePO4 Batteries: Battery protection in case of high temperatures and particularly in case of low temperatures < 0° C. Highly recommended, if the battery temperature might drop below 0 °C during operation.
  • Charging Aid for Deeply Discharged Lead Batteries: Gentle preliminary charging of the (lead-acid, gel, AGM) battery to 8 V, followed by powerful support of the battery, in case of possibly switched-on consumers.

Technical Details

Input from the vehicle starter battery "+ IN Start"
Vehicle Starter Battery Nominal Voltage 12 V
Min. Battery Capacity (Size), recommended 80 Ah
Input Voltage Range (EURO 6+), D+, controlled 10.5 ‐ 16.5 V
Input Overvoltage Disconnection (EURO 6+), max. 16.5 V
Power Consumption max. 1085 W
Current Draw (at lowest input voltage) max. 0.1 A ‐ 95 A
Current Draw Limited, 3 Switch Positions "IN Limit" 77 A, 63 A, 50 A
Auxiliary Charging, Charge/Trickle Charg. 12 V Starter Battery
for External Mains Charging Mode, Switch Position "B" 0 ‐ 5 A
Activation Control Input "D+", from D+, Terminal 15, Ignition 8 ‐ 16.5 V
IN "Start" Voltage Sensor Cables "Vs-" and "Vs+" yes / yes
Terminal "TR", Signal for Bypass Relay / max. 12 V / 1 A
Charging Port at the Board Supply Battery "+ OUT Board"
Charging/Floating/Load Curr., controlled, IU1oU2, Lead, LiFePO 0 A ‐ 70 A
Reduction at Switch Position "OUT Limit" 0 A ‐ 50 A
Lead-Acid, Gel, AGM Batteries Nominal Voltage 12 V
     Capacity (Battery Size), recommended / up to 100‐460 / 620 Ah
     Lead Charging Programs Stored in the Memory 4
     Prelim. Charg. Current (Deeply Discharged Batt. <8 V) max. 35 A
     Safety Charging Voltage at Battery Overtemperature 12.80 V
LiFePO4 Battery Nominal Voltage 12 V (12.8 -13.3  V)
     Capacity (Battery Size), recommended / up to 100‐460 / 620 Ah
     LiFePO4 Charging Programs Stored in the Memory 4
    Safety Charging Voltage at Battery Overtemperature 12.80 V
Input "T T" for Battery Temperature Sensor "Board" yes
OUT "Board" Voltage Sensor Cables "Vb-" and "Vb+" yes / yes
Quiescent Current, Standby 16 mA
Charging Timer 3‐fold
Ripple Factor Voltage < 30 mV rms
Limit of Charging Voltage "+OUT Board" (Consumer Protection) 15.00 V
External Overvoltage Disconnection "+OUT Board" (20 sec.) 15.50 V
Safety Protection against Short-circuit/Back Discharge yes
Fitting Position of Unit any
Temperature Range ‐20 to 45° C
Speed-controlled, Temperature-controlled Fan yes
Gradual Reduction of Charging Capacity at Overtemperature yes
Safety Disconnection in Case of Overheating yes
Dimensions, incl. Fastening Flanges and Terminals (LxWxH) 235 x 160 x 71 mm
Weight 1300 g
Ambient Conditions, Humidity of Air: max. 95 % RH, no condensation
Delivery Scope: Temperature Sensor, Manual  

Charging Programs

1 „Gel“: Charging Program for Gel Batteries, Characteristic Line IU1oU2
Adapted to closed, gas-tight gel/dryfit batteries with determined electrolyte, which are generally requiring a higher charging voltage level and longer dwell times U1 to achieve short charging times with particularly high capacity storage and to avoid total discharge. Also recommended for EXIDE MAXXIMA a high-current battery in AGM filament technology.

2 „AGM“: Charging Program for AGM/Fleece Batteries, Characteristic Line IU1oU2
Adapted to charging closed, gas-tight AGM (absorbed glass mat) batteries and batteries in lead-fleece technology requiring a particularly high level U1 with adapted dwell times for full charging and after that a moderate level U2 for trickle charge (round cell and plate technology).

4 „UNIVERSAL“: Charging Program for Lead, Acid/Lead-Acid Batteries: Characteristic Line IU1oU2
Universal program for charging and conservation of charge of acid batteries in vehicles (mixed operation mobile/stationary). Still offers short charging times, good charging factor and good acid mixing with average level U1 for open and closed, low-maintenance, maintenance-free standard, drive, lighting, solar and heavy duty batteries.

Li „LiFePO4“: Charging Program for Lithium Batteries, Characteristic Line IU1oU2
Charging program for lithium LiFePO4 batteries with completely integrated electronic system and safety circiut (BMS).

Downloads

Anleitung Katalog

Accessories

LCD Charge Control S VCC

LED Remote Control S 2076

The LCD-Charge Control S-VCC (Art.-No. 1248) is a comfortable, easily operable control and operating unit. It indicates the status of the device, the current charging phase, the voltage of board and starter battery, as well as the instantaneous charging current. The large, clearly arranged display is illuminated and offers excellent legibility with very low current consumption.

Retrofit of the unit, also subsequently, is easily possible by means of the plug-and-play connection, and due to the compact design it can be installed at almost any location.

LCD-Charge Control S-VCC

LED Remote Control S

Trenn Relais 12V 200A 220112V / 200A

  Umschalt Relais 12V 60A 2202
12V / 60A

ByPass-Relay 12V / 200A (Art-No. 2201) which is used for the possibility, that a strong consumer could discharge the supply battery much more than the charging converter is able to recharge, for example in the operation of an air conditioner with powerful inverter during driving. In case of such a high consumption the ByPass-Relay will be activated by a special switching contact of the device to bridge the charging converter. After reduction of consumption the ByPass-Relay will be deactivated and the charging converter takes care of a controlled full charge of the supply battery.

Back Contact Relay 12V / 60A (Art.-No. 2202) with bottom contact for installation at an existing Schaudt "Elektroblock (EBL)".

 

BootAlso available with humidity-proof electronic system:
Charging Converter VCC 1212-70 
(Art. 13328)

 

EMHC CIVD
Go to top