Solar Charging Controller MPP 430 Duo Digital (Boat)Device with humidity-proof electronic system - Article-No. 11725 |
|
![]() |
max. 430 Wp Module Capacity max. 26 A Module Current max. 50 V Module Voltage |
1 Supply- and 1 Starter Battery |
Please notice, that the device is only suitablte for solar panels up to the maximum power (Wp) and below the maximum persmissable voltage (Voc). In addition the controller is not suitable for an input-side connection (+/- solar panels) of wind, water, fuel or motor generators, power supplies, batteries or other current sources.
MPP Solar Controller for high-quality campers, caravans and boats. VOTRONIC Solar Controllers of series "MPP" (Maximum-Power-Point) with characteristic line of charging „IU1oU2“ are the link between solar panel(s) and battery (batteries). Controllers according to the MPP technology are continuously and automatically calculating the maximum power yield (MPP) of the solar modules several times per minute. The voltage surplus of the solar module will be transformed to a higher charging current for the battery (realised by high-frequency switching controller technology with high efficiency). This surplus of charging current ensures short charging times and the best possible power yield of the solar system. Working fully automatically and maintenance-free, the solar controllers MPP offer the following functions:
Nominal Operating Voltage (AC) in [V] | 12 |
Capacity Solar Module max. [Wp] | 430 |
Current Solar Moddule max. [A] | 26.0 |
Voltage Solar Module max. [V] | 50 |
Charging Current Batt. I / II max. [A] | 31.5 / 1.0 |
Characteristic Line of Charging | IU1oU2 |
Battery Type adjustable | Acid/Lead-Acid, Gel, AGM, LiFePO4 |
Current Consumption Stand-by in [A] |
0.004 |
Overcharge Protection | yes |
Reverse Current Protection (during the night) |
yes |
On-board mains suppression filter |
yes |
Number of Charging Ports | 2 |
Protection against Overload, Overtemperature, Short-circuit |
yes |
Connection for Temperature Sensor |
yes |
Compensation of voltage loss on charging cables | yes |
Connection for LCD-Solar-Computer S |
yes |
Signal Output "EBL" for Display "Solar" Charging Current Battery |
yes |
Temperature Range [°C] | -20 to +45 |
Dimensions (WxDxH) in [mm] - Dimensions incl. mounting flanges, without connections | 131 x 40 x 77 |
Weight in [g] | 285 |
Mark of conformity (CE) | |
Ambient Conditions, Humidity of Air: max. 95 % RH, No Condensation | |
Delivery Scope: Operating Manual |
![]() |
„Gel“: Charging Program for Gel Batteries, Characteristic Line IU1oU2 Adapted to closed, gas-tight gel/dryfit batteries with determined electrolyte, which are generally requiring a higher charging voltage level and longer dwell times U1 to achieve short charging times with particularly high capacity storage and to avoid total discharge. Also recommended for EXIDE MAXXIMA a high-current battery in AGM filament technology. |
![]() |
„AGM“: Charging Program for AGM/Fleece Batteries, Characteristic Line IU1oU2 Adapted to charging closed, gas-tight AGM (absorbed glass mat) batteries and batteries in lead-fleece technology requiring a particularly high level U1 with adapted dwell times for full charging and after that a moderate level U2 for trickle charge (round cell and plate technology). |
![]() |
„UNIVERSAL“: Charging Program for Lead, Acid/Lead-Acid Batteries: Characteristic Line IU1oU2 Universal program for charging and conservation of charge of acid batteries in vehicles (mixed operation mobile/stationary). Still offers short charging times, good charging factor and good acid mixing with average level U1 for open and closed, low-maintenance, maintenance-free standard, drive, lighting, solar and heavy duty batteries. |
![]() |
„LiFePO4“: Charging Program for Lithium Batteries, Characteristic Line IU1oU2 Charging program for lithium LiFePO4 batteries with completely integrated electronic system and safety circiut (BMS). |
|
Standard version: |
|